>  |
 |

| ISLAND RACING
CLEANOUT PLUG PIN KIT IR-CPPK $28.95
Many Yamaha jetboat owners are aware that a cleanout plug blowout can result in major damage and a possible sunken jetboat. Pins lock release mechanism in place virtually eliminating the risk of having a plug blowout. Pins, rings, and lanyards are made of 100% stainless steel. A spring loaded ball prevents pins from walking out. Requires 3/16 drill bit for installation.
|
|
|
|
ISLAND RACING FUEL / VAPOR SEPERATOR KIT JETBOAT SINGLE ENGINE $199.95 USCG A1 Fuel Line JETBOAT TWIN ENGINE $269.95 USCG A1 Fuel Line
"SUCK FUEL NOT AIR" A MUST FOR ALL 2-STROKE JETBOATS TWIN ENGINE JETBOATS CAN USE TWO SINGLE ENGINE KITS FOR THE ULTIMATE IN PERFORMANCE RELIABILITY ISLAND RACING'S FUEL / VAPOR SEPERATOR KITS are the finest available on the market! There are other seperators on the market that contain inferior plastic fittings, cheap hardware store vinyl tubing, and thin walled chambers. Our kits contain all brass fittings, Shields USCG approved A1 fuel line, and a rugged high polished aluminum chamber design.
|
 |
| SINGLE ENGINE KIT WITH URETHANE FUEL LINE |
|
|
 |
| TWIN ENGINE |
|
|
ISLAND RACING OIL INJECTION BLOCK OFF KIT IR-OIBO-Y3 $16.95
Add reliability, engine protection, and performance by removing the oil injection system and converting to pre-mix. Premixing the fuel allows you to run higher quality oils that otherwise cannot pass through the oil injection system. Our plates are made from billet aluminum not stamped aluminum like others currently on the market and are anodized to prevent corrosion making our OIL INJECTION BLOCK OFF KITS the highest quality, most complete kits available on the market.
|
|
ISLAND RACING OIL INJECTION LINE CLAMP KIT IR-OILCK $16.95
A MUST FOR ALL OIL INJECTION SYSTEMS Prevent engine failure by replacing factory installed "zip tie" clamps with 100% stainless steel Oetiker clamps. Kit contains all the correctly sized clamps for one engine. Clamps lines from oil pump to airbox.
|
|
ISLAND RACING OIL INJECTION LINE FILTER KIT IR-OILFK-YJB $14.95
|
|
ISLAND RACING OIL INJECTION LINE REPLACEMENT KITS
Kits contains the finest quality line which far exceeds OEM lines and 100% stainless steel Oetiker clamps
PUMP KIT IR-OILRK-P $24.95 Replaces and clamps oil lines from pump to carbs Clamps return oil lines from pump to connector Clamps supply oil lines from pump to oil filter Clamps oil bleeder line ( One Kit Required Per Engine )
TANK KIT IR-OILRK-T $39.95 Replaces and clamps supply oil lines from tank to oil filter Replaces and clamps return oil lines from tank to connector ( One Kit Required Per Boat )
|
 |
| PUMP KIT |
|
|
 |
| TANK KIT |
|
|
ISLAND RACING PRIMER KITS $64.95 Single Engine $109.95 Dual Engine
Eliminate hard starting and add performance by adding an ISLAND RACING PRIMER KIT. Engines start INSTANTLY! Removing the choke plates allows additional airflow through the carbs resulting in increased performance. Our kits use all brass fittings and premium urethane tubing making our kits the finest available.
|
|
ISLAND RACING SECONDARY BILGE PUMP KIT IR-SBPK-500 $109.95 500 GPH Pump IR-SBPK-750 $129.95 750 GPH Pump
Our SECONDARY BILGE PUMP KIT adds a second bilge pump to your jetboat. Internal float switch allows direct connection to the battery allowing pump to operate only when water is detected and does not "self cycle" causing battery drain. A MUST for jetboats that spend extended time in the water. Our kits contain all marine grade wiring and components.
|
|
ISLAND RACING SPARK PLUG INDEX WASHER KIT IR-SPIWK $24.95
Our SPARK PLUG INDEX WASHER KIT allows you to “index” or align the direction of the electrode for more efficient combustion, HIGHER HORSEPOWER, and HIGHER PEAK RPM. Washers are made from 100% Stainless Steel and will not corrode in marine environments. Washers are reuseable.
|
|
ISLAND RACING TOW VALVE KIT IR-TVK12 $24.95 ( 1/2" Hose ) IR-TVK58 $24.95 ( 5/8" Hose )
Our Tow Valves bodies are 450PSI plated brass construction. Full flow inner diameter doesnt restrict cooling water. During towing situations or running on one engine, it's mandatory to shut off the inlet water hose of the downed engine to prevent damage. ( One per engine required )
|
|
ISLAND RACING VF3 REED VALVE KIT $539.95 ( PER ENGINE )
YAMAHA XR1800
ADD 60-100+ RPM INSTANTLY
DO YOU WANT THE FASTEST, HARDEST ACCELERATING BOAT AROUND? THESE REEDS ARE A MUST! GAINS UPWARD OF 100 RPM PER ENGINE CAN BE SEEN WITH THIS REED CAGE KIT. THE 16 PETAL DESIGN PRACTICALLY DOUBLES THE AIR DELIVERY OVER THE STOCK REED SYSTEM.
|
|
ISLAND RACING WATER STRAINER $32.95
Keep your cooling system free from unwanted debris by adding an inline water strainer. Prevent overheating and possibly a damaged engine caused by clogged cooling passages. Inlet and outlet fittings sold seperately and are available for ALL JETBOAT APPLICATIONS.
|
|
ISLAND RACING WATER STRAINER KIT - YAMAHA JETBOAT IR-WSK-YJB-12 $64.95 2-Stroke 1/2" Hose IR-WSK-YJB-58 $64.95 4-Stroke 5/8" Hose
Our kit contains all the parts to plumb and mount a water strainer system on your Yamaha Jetboat. Use one kit per engine.
|
|
|
|
 |
 |
 |